Bosch KGN36VI3AA 351L Instructions For Use Manual page 22

en
Fault
Controls have reduced
luminosity.
Displays do not illuminate.
Appliance is not cooling,
temperature display and light
are lit.
Freezer compartment door
was open for a long time;
temperature is no longer
reached.
Condensation accumulates
on the surface of the
appliance and on the shelves
inside.
22
Possible cause
When the appliance is not
used for some time,
the display on the fascia
switches to energy saving
mode.
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Showroom mode is
switched on.
The evaporator (refrigeration
generator) in the
NoFrost system is covered
in thick ice and can no
longer be defrosted fully
automatically.
The effect is reinforced if
ambient temperatures are
warm and humid.
Remedial action
As soon as the appliance is again used, e.g.
the door is opened, the display switches back
to normal illumination.
Connect mains plug. Check whether the power
is on, check the fuses.
Hold down temperature selection button
fig. "/2 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether your
appliance is cooling.
To defrost the evaporator, remove the frozen
food with the compartments, insulate well
and store in a cool location.
Switch off the appliance and move it away
from the wall. Leave the appliance door open.
After approx. 20 min. the condensation begins
to run into the evaporation pan, at the rear of
the appliance.
To prevent the evaporation pan
from overflowing in this case, mop up the
condensation with a sponge.
The evaporator is defrosted when the water
stops running into the evaporation pan. Clean
the interior. Switch the appliance
back on again.
Wipe away the water with a soft, dry cloth.
Open the appliance as briefly as possible
■
Make sure that the appliance is always
■
closed properly.