Table of Contents
Advertisement
6. HEATER ASSEMBLY & INSTALLATION
Tools Needed: (not supplied)
Adjustable Wrench or wrench set, Slip Joint Pliers, Phillips Screwdriver-Medium Blade (#2 or #3
blade), Sheet Metal Snips, Drill and Masonry Bit for lag anchors (if mounting on concrete patio),
Plumbing Seal/Tape for Joints, Soapy Water: Spray Bottle or Paint Brush for leak testing.
NOTE: The top surface of the heater base is 3 1/2" above patio deck. Ensure the gas supply pipe
extends sufficient length above patio deck and heater base to allow installation of 1/2" Female
Quick Connect (supplied); allow minimum 18" of 24Vac power supply wire above deck for connec-
tion to heater wiring.
1. The 1/2" gas supply pipe can be located either external to or routed through the heater base:
External to the heater base (9" / 228 mm from post center to outside edge of base)
Routed through a 1.125" [28.5mm] hole cut in heater base. Trim base sheet metal at one of
the mounting hole locations to suit 1.125" hole in underlying base plate. (Post center to gas
supply hole: 4.5" / 114 mm).
2. Install heater base to patio deck using appropriate
hardware such as 5/16" lag screws (qty 3 or 4 field
supplied) through the holes in the heater base
- OR -
Use the supplied brackets (qty 3) as the fastening
solution (hardware to anchor to deck field supplied).
3.
Fasten post to heater base using (qty 6) sheet metal
screws supplied.
4. Connect gas hose to burner (flare connection) and tighten
connection with wrenches.
9
ALTERNATE BASE
MOUNT WITH
BRACKETS
4BN/L6,4SN/L5 Manual
IM100310
RD: DEC 2013
RL: 1B
Advertisement
Table of Contents
