Advertisement
D
Setup for an Existing Network Connection
If in case you have changed the Private Network Name of your
existing network, you may use the Simple Connect Button of your
HL117E and the other devices as indicated below:
Step 1
HomePlug X
(Your new HomePlug)
Press the Simple Connect button of your HomePlug
1
AV X for 10 SECONDS. After you release the button,
the Power
OFF and turn ON.
Step 2
HomePlug X
(Your new HomePlug)
Press the Simple Connect Button of HomePlug AV Y for
TWO SECONDS. The Power LED
will continuously blink. If
the Power LED did not blink, press the Simple Connect button
HomePlug Y
(A HomePlug that
belongs to the existing
network)
and Powerline Activity
LED will turn
HomePlug Y
(A HomePlug that
belongs to the existing
network)
2
again for two seconds.
MODEL
HL117E
Step 3
HomePlug X
(Your new HomePlug)
3
Step 4
HomePlug X
(Your new HomePlug)
To confirm if the connection has established, check the LEDs. The Power LEDs and
4
the Powerline Activity LEDs on all HomePlugs would be ON.
Press for 5 to 6
SECONDS to perform
factory defaul reset.
HomePlug Y
(A HomePlug that
belongs to the existing
network)
Within two minutes, press the simple connect button of
HomePlug AV X for TWO SECONDS.
HomePlug Y
(A HomePlug that
belongs to the existing
network)
NOTES:
•
When joining an existing network, you only have
to pair it to one HomePlug AV that belongs to the
existing network.
•
The Ethernet Activity LED
will only be lit if it is
connected to an Ethernet device (e.g. computer,
laptop, etc) through an Ethernet cable.
•
To perform RESET to factory defaults, press the
Simple Connect button for 5 to 6 SECONDS.
Advertisement
