Bosch FLEXIDOME IP starlight 7000 VR Installation Manual page 27

FLEXIDOME IP starlight
7000 VR
6 Connection via web browser
The unit must have a valid IP address and a compatible subnet
mask to operate on your network. By default, DHCP is pre-set at
the factory to On and so your DHCP server assigns an IP
address. With no DHCP server the default address is
192.168.0.1
To view the camera in your web browser:
1.
2.
3.
Note:
To see live images in your browser it might be necessary to
download and install the MPEG-ActiveX from the Bosch
download store.
Protected Network
If a RADIUS server is used for network access control (802.1x
authentication), the unit must be configured first. To configure
the unit, connect it directly to a computer using a network cable
and configure the two parameters, Identity and Password. Only
after these have been configured can communication with the
unit via the network occur.
IP Helper tool
Alternatively, use the IP Helper tool to detect Bosch devices on
the network:
1.
2.
3.
4.
Bosch Security Systems
Start the Web browser.
Enter the IP address of the unit as the URL.
During initial installation, confirm any security questions
that appear.
Access the Bosch download store (http://
downloadstore.boschsecurity.com/).
Download and install IP Helper.
Choose your specific camera from the list of cameras
shown in the table on the left of the screen
Click Open in browser to view the camera interface.
Connection via web browser | en
2016.06 | v1.0 | AM18-Q0710
27