Bosch FLEXIDOME IP starlight 7000 VR Installation Manual page 19

FLEXIDOME IP starlight
7000 VR
4.
5.
6.
7.
8.
9.
10. Close the cover on the conduit and position the conduit
11. Feed the other camera cabling through the cable hole in the
12. If IP66 water ingress protection is required, connect the
13. Mount the camera to the SMB using the 3 supplied screws
Bosch Security Systems
Use the supplied screws (pozidrive DIN7505-B 50mm) to
securely attach the SMB to the surface.
Feed the Ethernet RJ45 cable from source through the
ceiling into the SMB
Remove the cover from the SMB cable conduit and slide
out the rubber seals at either end.
Thread the Ethernet cables from the camera and source
through the seals (they can be pulled open to fit the
cables). If required, use the larger bore seal (supplied in
parts package) to fit thicker cables.
Slot the seals (with cables) into either end of the conduit.
Connect the Ethernet cables inside the conduit using the
supplied RJ45 shielded connector.
inside the SMB.
SMB.
camera cabling to the source cabling inside an IP66
approved box.
(M5x16mm torx).
Installation | en
2016.06 | v1.0 | AM18-Q0710
19