Crevice Tool; Adjusting Suction Power - Philips FC8199/01 Manual

English
8
2 Push the rocker switch on top of the floor nozzle with your foot to make the brush strip for
cleaning hard floors come out of the nozzle housing (Fig. 9).
3 Push the rocker switch on the other side to make the brush strip disappear into the floor
nozzle housing (Fig. 10).

Crevice tool

- You can use the crevice tool to clean hard-to-reach places quickly and conveniently.
- You find the crevice tool in the crevice tool compartment of the appliance. (Fig. 11)
- You can connect the crevice tool to the tube or directly to the handgrip of the hose.
1 To connect the crevice tool, insert the tube or handgrip into the small nozzle while turning
a little.
small nozzle (FC8199 only)
- You can use the small nozzle to clean small areas, e.g. the seats of chairs and sofas (Fig. 12).
- You can connect the small nozzle to the tube or directly to the handgrip of the hose.
1 To connect the small nozzle, insert the tube or handgrip into the small nozzle while turning
a little.
using the appliance
Vacuuming
1 Pull the mains cord out of the appliance and put the plug in the wall socket.
2 Press the on/off button on top of the appliance with your foot to switch on the
appliance. (Fig. 13)

adjusting suction power

During vacuum cleaning, you can adjust the suction power with:
- the suction power slide on the handgrip (Fig. 14).
- the electronic suction power control on the vacuum cleaner (FC8199 only). (Fig. 15)
Note: Use maximum suction power to vacuum very dirty carpets and hard floors. Use minimum suction
power to vacuum curtains, tablecloths etc.
Parking the tube
- If you want to pause for a moment, insert the ridge on the nozzle into the parking slot to park
the tube in a convenient position. (Fig. 16)
storage
1 Switch off the appliance and remove the mains plug from the wall socket.
2 Press the cord rewind button to rewind the mains cord (Fig. 17).
3 After use, store the crevice tool in its holder (Fig. 11).
4 Put the appliance in upright position and insert the ridge on the floor nozzle into the storage
slot on the appliance (Fig. 18).
4222_003_3561_1_DFU-booklet_v2.indd 8 04-05-11 15:03