Table of Contents
Advertisement
Installer Setting - Thermistor
This is the function to select the temperature sensor to judge the room temperature.
<Thermistor Table>
Temperature sensor selection
01
Remote controller
02
Indoor unit
Cooling
03
2TH
Heating
!
NOTE
* The function of 2TH has different operation characteristics according to the product.
*
Remote controller image may different upon models accordingly.
If pressing
1
seconds, it enters into remote
controller setter setup mode.
- If pressing once shortly, it enters
into user setup mode. Please press
more than 3 seconds for sure.
If moving to room temperature perception
2
sensor selection menu by pressing
button, it indicates as picture below.
Set Thermistor value by pressing
3
button. (01: Remote Controller,
02: Indoor, 03: 2TH)
Function Code
Press
4
Pressing
5
After setup, it automatically gets out of
setup mode if there is no button input for
25 seconds.
When exiting without pressing set button,
the manipulated value is not reflected.
Operation in remote controller temperature sensor
Operation in indoor unit temperature sensor
Operation of higher temperature by comparing indoor unit's
and wired remote controller's temperature. (There are prod-
ucts that operate at a lower temperature.)
Operation of lower temperature by comparing indoor unit's
and wired remote controller's temperature.
INSTALLATION INSTRUCTION
button long for 3
Thermistor setting
button to save.
button will exit settings mode.
Function
19
Advertisement
Table of Contents
