Table of Contents
Advertisement
INSTALLATION INSTRUCTION
14
3
Please fix remote controller upper part into
the backplate attached to the surface of
the wall, as the picture below, and then,
connect with backplate by pressing lower
part.
- Please make sure to leave no gaps on the
top, bottom, left or right sides between
the remote controller and backplate.
- Before assembly with the backplate,
arrange the Cable not to interfere with cir-
cuit parts.
<Connecting order>
Wall
Side
Remove remote controller by inserting a
screwdriver into the lower separating holes
and twisting to release the controller from
backplate.
- There are two separating holes. Please in-
dividually separate one at a time.
- Please be careful not to damage the in-
side components when separating.
<Separating order>
Wall
Side
4
Please refer to the following directions
when connecting the indoor unit and the
wired remote controller together.
- Please connect the cables as shown in
the figure below when connecting the
plug type cable from the indoor unit's
C/BOX and the housing type of the exten-
sion cable.
Wall
Signal
Side
GND
!
• Specification of LG supplied extension
cable: AWG#22, 3 core shielded.
(Model : PZCWRC1)
* Apply enclosed noncombustible con-
- When connecting Terminal Blocks of the
indoor C/BOX and the wired remote con-
Wall
troller with the extension cable, refer to
Side
the steps below.
① Remove the screw on the cable which
② Remove the housing of the provided 32
Please check if the connectors
are connected properly.
C/BOX Cable (Plug type)
Extension cable(housing type)
Yellow
12 V
Red
Black
CAUTION
duit(metal raceway) totally or use FT-6
rated cable or above level in case of local
electric & building code that requires
plenum (CMP) cable usage.
is fastened to the wired remote con-
troller's Terminal Block by loosening
with a screw driver.
ft extension cable with a cutting nipper
and peel it as shown in the figure
below. (when purchasing the extension
cable at the site directly, please peel it
as shown in the figure below.)
0.394 inch(10 mm) ± 0.118 inch(3 mm)
Indoor
Unit side
Advertisement
Table of Contents
