Table of Contents
Advertisement
MULTI-METER
The multi-meter on your generator switches between voltage (e.g. 120.1), frequency (e.g. 60.0H), and runtime (e.g.
12.3) every 5 seconds. When you first use the generator, the meter will count runtime, but will not store runtime
until the generator is run for longer than 2 hours at a time. Once the generator has been run for more than 2 hours
at a time, the meter will track runtime normally. For an example, as well as more explanation, please refer to Table
4 below.
SESSION NUMBER
SESSION LENGTH
1
1 hr 30 min
2
3
4
5
Every 50 hours, the meter will display "]--[", which is to remind you to perform 50-hour maintenance. Consult the
maintenance chart for recommended procedures. The display code will appear every 15 seconds for 6 minutes.
After 6 minutes, or after the generator is shut down and restarted, the code will clear and display voltage, frequency,
and runtime, as before.
USING YOUR GENERATOR
HOUR METER
AT END OF SESSION
1.5
30 min
0.5
1 hr
1
3 hr
3
2 hr
5
DOES THE METER
RESET?
Meter will show "1.5" just before it is shut off,
Yes, to 0.0
but it has not been run for 2 hours at a time
yet.
Meter will show "0.5" just before it is shut off,
Yes, to 0.0
but it has not been run for 2 hours at a time
yet.
Meter will show "1.0" just before it is shut off,
Yes, to 0.0
but it has not been run for 2 hours at a time
yet.
Meter will show "3.0" at the end, since it has
been run for more than 2 hours. It will not in-
No
clude the 3 hours (1.5 + 0.5 + 1) the generator
was run before.
Meter will show "5.0" at the end, since it has
been run for 3 + 2 = 5 hours. The meter is
No
counting normally, and will continue operating
normally.
COMMENTS
27
Advertisement
Table of Contents
