Blowing Operation; Maintenance - Vacmaster VJ607 Operator's Manual

This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN CANADA,
CSAZ94.3) BEFORE USING BLOWER.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
1. Verify that the power cord is disconnected from the outlet.
2. Make sure the container is empty before using as a blower.
3. Remove hose from the vacuum port.
4. Insert the locking end of the hose into the blowing port on the back side of the power head and lock into
position. (fig. 1)
5. Fit the desired extension wand and or nozzle to the vacuum hose. (fig. 2)
6. Ensure the power switch is turned off and plug in the power supply. (fig. 3)
7. Before turning on the vac, firmly hold loose end of the hose. Turn the motor on by flipping the switch to
the 'I' ON position. (fig. 4)
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Disconnect the hose from the vacuum. (fig.2)
3. Undo the latches and remove the power head from the container. (fig.3)
4. Clear all dirt or debris from the container and hose. (fig.4)
5. Clean the foam filter by washing it with water and a mild soap. (fig.5)
6. Check the hose, attachments, and power cord to verify that they have not been damaged.
IMPORTANT!
Clean or change the cartridge filter regularly for best performance. ALWAYS USE
CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used with out the cartridge filter, the
motor will burn out and the warranty will be voided. Always keep spare filters on-hand.

BLOWING OPERATION

MAINTENANCE

9