Elation FUZE WASH Z120 User Manual page 8

S A F E T Y I N S T R U C T I O N S A N D G U I D E L I N E S
•
DO NOT TOUCH the fixture housing during operation. Turn OFF the power and allow
approximately 15 minutes for the fixture to cool down before serving.
•
DO NOT shake fixture, avoid brute force when installing and/or operating fixture.
•
DO NOT operate fixture if the power cord has become frayed, crimped and/or
damaged. If the power cord is damaged, replace it immediately with a new one
of similar power rating.
•
DO NOT block any air ventilation slots. All fan and air inlets must remain clean and
never blocked. Allow approx. 6" (15cm) between fixture and other devices or a
wall for proper cooling.
• When installing fixture in a suspended environment, always use mounting
hardware that is no less than M10 x 25 mm, and always install fixture with an
appropriately rated safety cable.
• Always disconnect fixture from main power source before performing any type of
service and/or cleaning procedure. Only handle the power cord by the plug end,
never pull out the plug by tugging the wire portion of the cord.
• During the initial operation of this fixture, a light smoke or smell may emit from the
interior of the fixture. This is a normal process and is caused by excess paint in the
interior of the casing burning off from the heat associated with the lamp and will
decrease gradually over time.
• Consistent operational breaks will ensure the fixture will function properly for many
years to come.
• Use the original packaging and materials to transport the fixture in for service.
w w w . e l a t i o n l i g h t i n g . c o m
8
FUZE WASH Z120™ User Manual