MTX Bass Slammer FEN10U Installation Directions

FEN10
Enclosure Volume: .6 Cubic Foot, Sealed
READ ALL DIRECTIONS CAREFULLY BEFORE BEGINNING
MOUNTING LOCATION: The enclosure mounts behind rear panel on passenger's side and replaces factory cargo net.
TOOLS FOR INSTALLATION:
Phillips Head Screwdriver
11/32" Socket
Ratchet
INSTALLATION: Follow the steps below
1. Start by removing the header trim, if you are standing at the rear of vehicle hatch facing in with hatch open over your
head this is the panel at the hinged section of hatch. This panel is held in place with four snaps. Pull from one side and
work over to the other.
2. Remove seal plate at bottom of hatch opening. Trim piece is held down by eleven snaps. As like the previous piece start
from one end and pull up slowly working your way over to the other side.
3. Remove tow screws on passenger side of vehicle. These are just left of the jack storage at the very rear of the opening.
They look like knobs, just twist by hand, no tools are needed.
4. If equipped with third row seating remove seat and then seat belt on passenger side. Unsnap seat belt cover, pull from
bottom of cover remove T-50 torx head bolt.
5. Remove pillar cover on passenger side rear, directly above the screws you removed in Step "3". Panel is held into place
with 3 clips, pull in direction away from the window towards center of vehicle, top first then bottom.
6. Raise second row seating, remove carpet trim panel behind seats. Panel is held into place with 6 clips, pull up on one
end and work your way over to the other.
7. Remove second row seating seat belt. Top of belt can be removed by lifting cover from the bottom to unsnap. Remove
15mm bolt. Bottom of seat belt is held into place with T-50 torx head, lift rubber boot to remove.
8. Remove pillar cover at passenger side rear door, panel is held into place with 4 clips. Start by pulling on top left, then top
right. Pull slowly to center of vehicle. Bottom right clip is clipped into plastic panel, be careful not to break.
9. Remove passenger side rear door sill trim. Held into place by 3 clips. Pull slowly from the front, it will unsnap easy.
15mm Wrench
T-50 Torx
6" Ratchet Extension