Table of Contents
Advertisement
Install Standalone Receivers on Exercise Equipment
This section explains how to install the xTV-8RLP standalone
receiver on the handlebars of selected equipment in the facility.
You can attach receivers to the handlebars of almost any exercise
equipment. However, for safety, the receiver must be installed on a
stationary location, so you cannot install it on handlebars that move.
Attach the receivers securely with the wire ties and neoprene pads.
When a receiver is properly attached to a piece of equipment, it
should not move. Proper installation is important to prevent moisture
from entering the receiver through the power connector and
damaging the electronics.
Remember to read and follow the instructions in this guide. If you do
not install the xTV-8RLP receivers according to these instructions,
you could void the Limited Warranty.
Installation and Maintenance Guide: Install Standalone Receivers on Exercise Equipment
Unpacking the Equipment
The standalone receiver is shipped with the following items:
• One or more xTV-8RLP Receivers as ordered
• Neoprene pad, 1 per receiver
• Wire ties, 4 per receiver
• CSAFE power cable or AC power adapter kit for your country,
1 per receiver (see Note below)
• These installation instructions
Note: The choice of a CSAFE power cable or AC power adapter kit
for a receiver is determined when the wireless equipment is ordered.
If a piece of exercise equipment is CSAFE compatible, you should
use a CSAFE power cable to power the receiver to simplify
installation.
If any items are missing, contact the dealer from whom you
purchased the unit or contact Cardio Theater Technical Support.
Required Tools
Obtain these tools before assembly:
• Tool to cut the wire ties
• Pliers to tighten the wire ties
Suggested Tool
You may want to add the optional power adapters to the self-
powered equipment in your facility. To purchase the optional power
adapters, check with your Precor dealer.
6
Advertisement
Table of Contents
