Table of Contents
Advertisement
2. Remove the entertainment option cover. See Figure 6. Tabs exist
on either side of the cover. Press in on the tabs and the cover
pops off. You can discard the entertainment option cover.
Figure 6: Remove entertainment option cover
Important: If you are replacing the integrated receiver,
disconnect the 5-wire cable from the display console, and then
pull the stereo plug (audio cable) out of the cover before
removing the receiver.
3. At the base of the display console, remove the audio cover. Place
a finger inside the audio cover to push it out of the display
console. You can discard the audio cover because it is replaced
with the headphone jack.
4. Separate the display console face from the console. See
Figure 7. Start at the top and work toward the bottom by
pressing in on five of the tabs that secure it. This provides easier
access to the 5-pin connector.
Installation and Maintenance Guide: Install Integrated Receivers on Display Consoles
Figure 7: Separate display console face
5. Hold the integrated receiver above the display console and feed
the audio cable through the opening in the base of the display
console. Let the audio cable hang loose.
CAUTION: It is critical that you attach the red wire on the
5-wire entertainment option cable to Pin 1. The word, PIN 1,
is inscribed on the back of the display console. An arrow
points to the location of Pin 1. The connector is keyed so it
will only connect one way. Do not force the connection.
6. Connect the 5-wire entertainment option cable to the display
console.
7. Reattach the display console face by aligning the tabs and
applying pressure to the display face.
8. Install the integrated receiver by aligning the two tabs and
applying pressure. Arrange the cables so when you reattach the
cover, you do not inadvertently pinch or damage the cables.
Important: Cable damaged by improper installation will not be
covered by the Limited Warranty.
10
Advertisement
Table of Contents
