Advertisement
EV3000-D manual
Command
49
Camera
Command
Power
on
at
EV3000-D
camera 2
Response
Description
50
Camera
Command
Power
off
at
EV3000-D
camera 2
Response
Description
51
Initialize
Command
PAN/TI
LT
EV3000-D
Response
Description
Equipment described herein may require US Government authorization for export purposes. Diversion contrary to US law
is prohibited. ©2008 United Vision solutions, Co., Specifications are subject to change. Check website:
Byte1
Byte2
FFh
Receiver
ID
Receiver ID=00h~FEh, Camera 2 is Thermal Camera (Clear Bit 6 of
Byte3 to Select Camera 2.) DC 12V IR power supply of Thermal
camera Will be electrically Turned On by EV3000-D Receiver
Without any command sending to thermal camera
DC12V Defroster supply will always be turned on state.
FFh
Receiver
ID
Receiver ID=00h~FEh, Camera 2 is Thermal Camera (Clear Bit 6 of
Byte3 to Select Camera 2.) DC 12V IR power supply of Thermal
camera Will be electrically Turned Off by EV3000-D Receiver
without any command sending to thermal camera. But DC12V
Defroster supply will always be turned on state.
FFh
Receiver
ID
Receiver ID=00h~FEh, Pan/Tilt will go to Preset position No."0"
which is stored in EEPROM of EV3000-D receiver when
manufactured in factory.
www.unitedvisionsolutions.com
Byte3
Byte4 Byte5
00h
09h
00h
00h
0Bh
00h
00h
0Fh
00h
Byte6
Byte7
0Ch
Checksum
(default
state).But
0Ch
Checksum
00h
Checksum
Advertisement
