Advertisement
EV3000-D manual
3. EV3000-D
installation Notes
Before operation the unit, you must read this user's Manual thoroughly and
retain it for future reference.
Before cleaning the unit, you must remove it from the wall or bracket.
You must clean it with a wet cloth. Never use liquid cleanser.
Enough space must be ensured to installation of this P/T and never rotate
PAN/TILT housing forcibly without driving by remote controller.
Be careful not to put this unit on an unstable stand, tripod, shelf, or Table.
Do not leave the unit in a location near heat sources or humidifier.
Be careful of electric overload on the electric terminal or extension cable,
otherwise there can be risk of permanent damage.
You must stop operation this unit and never connect the connector of the
cable to the unit in case of the following situations.
z
In case of the control cable being damaged.
z
When any liquid or unfavorable materials fall into the unit.
z When the unit doesn't work properly according to the instruction.
z When the unit fell down or the P/T was damaged.
You must make an expert examine the accessories whether they have the
same specific character when you need replacement of them.
You must install AC24V power source near the EV3000-D (within 10m)
Otherwise The EV3000-D will probably malfunction due to AC voltage
drop or critical noise etc.
Equipment described herein may require US Government authorization for export purposes. Diversion contrary to US law
is prohibited. ©2008 United Vision solutions, Co., Specifications are subject to change. Check website:
www.unitedvisionsolutions.com
Advertisement
