Advertisement
High sensitivity color camera
Main Speci cations
Pickup element
Total pixels
680(H) x 500(V)
E ective pixels
Imaging area
Pixel pitch
10.0(H) x 10.0(V) µm (Square pixel)
Scanning system
Scanning frequency
Synchronization
Video output
VBS output
Sync
0.3 Vp-p Negative polarity
Burst
0.3 Vp-p, More than 8 cycles
Impedance
Ω Un-balancing.
Signal-processing system
Signal to noise ratio (S/N)
minimum gain, without detail boost)
Resolution
Horizontal: 480 lines
Minimum photographic 0.009 lx ( C olor in full motion, maximum sensitivity setup, F1.4, 50 IRE
subject illumination
KP-DE500
setup, F1.4, 50 IRE)
0.00015 lx (Color 64 time accumulation, maximum
sensitivity setup. F1.4, 50 IRE)
0.000008 lx (Monochrome 64 time accumulation, maximum
sensitivity setup, F1.4, 50 IRE)
Sensitivity (Gain) setup
Electronic shutter
OFF(1/60), 1/100, 1/125, 1/250, 1/500, 1/1000, 1/2000 sec
Accumulation
magni cation setup
Backlight compensation
Light-measurement area: Nine area to selection is possible.
Dimensions
64
A
A
Vertical: 350 lines (In the central part)
in full motion
±1.5
±1.5
4
±1.5
6.3
(6.3)
17.1
The output for auto iris
lenses
White balance control
Camera title character
display
B/W Mode
*Only KP-DE500 (color)
)
Picture quality
adjustment menu
DNR
Power supply voltage
Current consumption
Lens mount
Ambient, operating
Ambient, storage
Vibration endurance
External dimensions
Mass
(169.9)
±1.5
163.6
±1.5
±1
14
2-1/4 M20 (DEPTH: 9)
A galvanometer system/video signal
From the following three modes to selection (factory set-ATW)
*Only KP-DE500 (color)
ATW: The mode which follows automatically
AWC
automatic setup
MANUAL: They are red and the mode which carries out blue
gain adjustment and unites a white with manual operation
character and a sign
A setup to either of two upper and lower sides of a screen is
possible in the position of a character.
OFF: The mode of xation on a color image
AU
image, the mode where ON changes automatically
In addition, it changes, as for luminous intensity from 3
stages of the HI, the MID and the LOW selective possibility
Change of AUTO / MANU (8 steps) (factory set-AUTO)
±1 V
The C / CS mount ( ange back adjustment mechanism it is attached)
*when in order for you to use with the e ciency which
long time is stabilized, it continues uses by all means
+40 ºC please use at below.
2
(10 - 200Hz XYZ direction each 30 minute)
*Please do not add the strong vibration over long time.
(The lens and the projection section are excluded)
Approximately 53g (The lens is excluded)
(10.8)
Advertisement
