Table of Contents
Advertisement
REAR HPF/OFF/LPF
j
Select High-pass-filter (HPF), Low-pass-filter(LPF) or
•
OFF (flat) mode.
REAR FREQ
k
Adjust frequency of HPF or LPF from 30Hz to 400Hz.
•
REAR INPUT LEVEL
l
Adjust input level (0.3V to 6V).
•
REAR INPUT L/R
m
Connect car audio with RCA cable.
•
POWER (GND/REM/+12V)
n
Connect +12V DC power cable, ground wire and remote
•
wire.
Fuse
o
SPEAKER OUTPUT
p
Connect to speakers.
•
2. Installation
Installation
You can mount the amplifier either under a seat or on the rear tray.
Note
•
To avoid interference, do not place the amplifier too
close to the car audio or antenna.
•
The supplied mounting screws are 14mm long. Make
sure that the mounting board is thicker than 14mm.
1
Place the unit on the location for installation.
2
Mark the positions of the four screw holes.
Advertisement
Table of Contents
