Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Philips CMP400/55
Summary of Contents for Philips CMP400/55
- Page 1 Register your product and get support at www.philips.com/welcome User manual...
-
Page 3: Table Of Contents
Contents 1 Important Safety Notice 2 Your car power amplifier Introduction What’s in the box Overview of the main unit 3 Installation Installation Connect speakers Connect car audio Connect power 4 Use your power amplifier Select crossover frequency mode Adjust frequency Adjust input level Adjust bass boost About the protector indicator Replace fuse 5 Product information... -
Page 4: Important
Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. 2009 © Koninklijke Philips Electronics N.V. All rights reserved. -
Page 5: Your Car Power Amplifier
2 Your car power amplifier Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With the amplifier, you can enjoy high quality sound performance with powerful bass and beats. - Page 6 k REAR FREQ • Adjust frequency of HPF or LPF from 30Hz to 400Hz. l REAR INPUT LEVEL • Adjust input level (0.3V to 6V). m REAR INPUT L/R • Connect car audio with RCA cable. n POWER (GND/REM/+12V) • Connect +12V DC power cable, ground wire and remote wire..
-
Page 7: Installation
3 Installation Installation You can mount the amplifier either under a seat or on the rear tray. Note • To avoid interference, do not place the amplifier too close to the car audio or antenna. • The supplied mounting screws are 25mm long. Make sure that the mounting board is thicker than 25mm. -
Page 8: Connect Car Audio
Connect car audio Option 1: High level input connection Connect the amplifier to your car audio with the supplied High level input connector. Left speaker Left speaker Car audio unit Right speaker Right speaker HI INPUT Purple White Green Grey Green/Black Grey/Black Purple/Black... -
Page 9: Connect Power
Connect power Make the power connection as illustrated below: • Connect the ground wire from the car to the • Connect the remote wire from the car audio to the √ With this connection, you can turn on/off the amplifier with the car udio. •... -
Page 10: Use Your Power Amplifier
4 Use your power amplifier Select crossover frequency mode You can select crossover frequency mode as below: Select this mode when mid- (high- range speakers and tweeters are pass-filter) connected for high frequency mode output. LPF (Low- Select this mode when woofer pass-filter) and subwoofer is connected for mode... -
Page 11: Replace Fuse
(20A x 2). If the fuse gets damaged immediately after it has been replaced, there may be an internal malfunction. In such case, consult your Philips dealer. -
Page 12: Product Information
5 Product information Note • Product information is subject to change without prior notice. Power output (RMS) - 4 ohm - 4 ohm (bridged) - 2 ohm Total harmonic distortion Signal to noise ratio Channel separation Frequency response Input sensitivity Input impedance Fuse rating Dimensions (DxWxH) -
Page 13: Troubleshooting
If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. - Page 14 © 2009 Koninklijke Philips Electronics N.V. All rights reserved. Document order number: CMP400_55_UM_V3.1...