Installation; Connect Speakers - Philips CMP400/55 User Manual

3 Installation

Installation
You can mount the amplifier either under a seat
or on the rear tray.
Note
•
To avoid interference, do not place the
amplifier too close to the car audio or antenna.
•
The supplied mounting screws are 25mm long.
Make sure that the mounting board is thicker
than 25mm.
1
Place the unit on the location for
installation.
2
Mark the positions of the four screw
holes.
3
Drill the holes with driller of
approximately 4mm in diameter.
4
Mount the unit with the supplied screws.

Connect speakers

Note
•
Use speakers with an impedance of 2 to 8 ohm
(4 to 8 ohm when used as a bridged amplifier).
•
Match the "left", "right", "+" and "-" terminals
correctly. Revised polarity may degrade sound
quality.
Option 1: Mono bridged mode: connect
2 speaker
Option 2: Stereo mode: connect 4 speakers
4 ohm
speaker 4 ohm
Option 3: Tri-mode: connect 6 speakers
4 ohm
speaker
FR FL
4 ohm 4 ohm
speaker speaker
FR FL
4 ohm
speaker
4 ohm
speaker speaker
FR FL
4 ohm
speaker
4 ohm 4 ohm
speaker
speaker
8 ohm 8 ohm
speaker speaker
EN
7