Panasonic CT-36SL13G Service Manual page 19

L-Board - CRT output
Plugs into the socket on the CRT neck.
To remove this board, first unplug the board from the CRT neck, then disconnect L1, L2 and L3
connectors, to disconnect the focus F1(red cable) & F2 (white cable) cables from the CRT socker,
pull the tab and release the cables (see figure),finally disconnect the screen cable from the D-
Board D16 (screen and heater).
To reinsert back the cables, remember the original position of cables, F1 (red cable) goes to A on
the CRT socket and F2 (white cable) goes to B on the CRT socket.
F1 and F2 cables release
To release screen GND cables from L-Board L11 & L12 connectors, insert a wire in both sides of
connector and pull upwards the cable, then remove the wire.
L11 and L12 cables release
G-Board
Mated to A-Board by three flexible connectors A1, A2, A3 and D40 from D-Board. To remove this
board, first unplug the four flexible connectors, then RT1 and G4connectors, then pull upwards
the board while unlock the tabs from the chassis tray.
Speakers
Each speaker is secured to a plastic base with 4 screws, and each plastic base is secured to the
from cabinet with two screws.
NOTE
When reassembling speakers be sure to connect the speaker wires to the correct speaker lead (+)
(-)
19