Quanser QNET 2.0 HVAC User Manual page 12

The unit is provided with a grounded cord to be used with a properly grounded outlet
only, this is a safety feature, do not disable it.
Caution
1. Place the small opening on the front of the QNET HVAC board over the mounting bracket on the NI ELVIS
(+)
II .
2. Slide the PCI connector of the QNET HVAC module end into the female connector on the NI ELVIS II
sure it is connected properly.
3. Connect the NI ELVIS II
4. Connect the NI ELVIS II
5. Connect the supplied QNET power supply to the QNET HVAC power jack on the QNET HVAC module.
6. Power the NI ELVIS II
7. Turn ON the Prototyping Board Power switch, ID #2 shown in Figure 3.1.
8. The Power and Ready LEDs on the NI ELVIS II
9. Verify that the +15 V, 15 V, +5 V and External Power LEDs on the QNET HVAC are lit green, and the Status
LED is red as shown in Figure 3.3. They indicate that the board has been properly connected to the NI ELVIS
(+)
II unit and that the QNET HVAC currently does not communicate with a PC.
(+)
power cable.
(+)
USB cable to the PC.
(+)
by turning ON the System Power Switch on the rear panel.
Figure 3.2: Ready and Power LEDs on NI ELVIS II
(+)
unit should be lit as shown in Figure 3.2.
QNET HVAC - User Manual
(+)
(+)
12
. Make