Quanser QNET 2.0 Quick Start Manual

Quick Start Guide:
STEP 1
Check Components and Details
Make sure your QNET Rotary Pendulum experiment includes the following components:
1
STEP 2
Additional Components Required
To complete your QNET Rotary Pendulum setup, you will also need the following hardware:
1
STEP 3
Install LabVIEW and Add-Ons
Make sure the following versions of LabVIEW™ and required add-ons are installed:
1. LabVIEW™ 2012 or later
2. NI DAQmx 9.5.5 or later
3. NI ELVISmx 4.4 or later
4. LabVIEW™ Control Design and Simulation Module 2012 or later
QNET 2.0 Rotary Pendulum
2
3
1. Quanser QNET 2.0 Rotary Pendulum board
2. 24VDC, 3.0A Power Supply
The QNET curriculum resources are
Note:
available for download at www.ni.com/qnets
2
1. NI ELVIS II or NI ELVIS II
workstation
2. +5VDC / 5A, +15VDC / 2A,
-15VDC / 0.8A Power Supply
3. USB Cable
Note: All references to NI ELVIS II
in this guide apply to both NI
ELVIS II and NI ELVIS II
+
+ devices.