c
1
2
3
4
5
6
7
8
9
0
!
"
§
English
3
Remove the two transport screws on the
top of the unit.
b
4
Remove the mounting sleeve with the
Install the car audio
removal keys.
c
5
These instructions are for a typical installation.
Install the sleeve into the dashboard and
However, if your car has different requirements,
bend the tabs outward to fix the sleeve.
d
make the corresponding adjustment. If you have
6
Place the rubber cushion over the end of
any questions regarding installation kits, consult
the bolt.
e
your Philips car audio dealer.
7
Slide the unit into the dashboard until a
click sound is heard.
f
Connect wires
1
8
Reconnect the negative terminal of the car
1
battery.
Pull out the ISO connectors from the car
dashboard and connect them to the bigger
end of the supplied standard connector.
a
2
Turn on
Connect the other end of supplied
standard connector to the unit.
b
1
Press
to turn on the unit.
•
If necessary, connect the following:
c
»
The available OSD (On-Screen Display)
Connector
Connect to/with
languages display.
1
Blue cable
Sub woofer out
2
Green/white
Parking (see ‘Connect
wire
parking brake wire’ on
page 16) switch (see
‘Connect parking brake
wire’)
3
White cable
Left front line out
4
Red cable
Right front line out
5
White cable
Left rear line out
6
Red cable
Right rear line out
2
Touch a language to select.
7
Pink wire
Camera
»
The OSD language changes to the
8
Yellow cable
Camera in
selected language immediately.
9
Yellow cable
Video in
•
To turn off the unit, press and hold
for
10 Yellow cable
Video out 2
more than 2 seconds.
11
Yellow cable
Video out 1
12 White cable
Left audio in
Set clock
13
Red cable
Right audio in
1
Touch
to display main menu.
2
Mount in the dashboard
2
Touch [Setting] to display setting menu.
1
3
Touch [Time].
If the car does not have an on-board drive
4
or navigation computer, disconnect the
Touch [Clock Mode] to switch between
negative terminal of the car attery.
clock mode options.
2
5
Ensure that car dashboard opening is within
Touch [Set Time].
a
these measurements: