TP-Link Archer C20 User Manual page 74

1 ) Visit http://tplinkwifi.net, and log in with the username and password you set for
2 ) Go to
Tips:
•
•
• Modify the LAN IP address of the router.
Note:
Most TP-Link routers use 192.168.0.1/192.168.1.1 as their default LAN IP address, it may conflict with the IP range
of your existent ADSL modem/router. If so, the router is not able to communicate with your modem and cause you
can't access the internet. To resolve this problem, we need to change the LAN IP address of the router to avoid
such conflict, for example, 192.168.2.1.
1 ) Visit http://tplinkwifi.net, and log in with the username and password you set for
2 ) Go to
3 ) Modify the LAN IP address as the follow picture shows. Here we take 192.168.2.1
4 ) Click Save.
• Restart the modem and the router.
1 ) Power off your modem and the router, and leave them off for 1 minute.
2 ) Power on your modem first, and wait about 2 minutes.
3 ) Power on the router, and wait another 1 or 2 minutes and check the internet
Downloaded from ManualsNet.com
the router.
Network > MAC
Some ISP will register the MAC address of your computer when you access the internet for the first time
through their Cable modem, if you add a router into your network to share your internet connection, the ISP will
not accept it as the MAC address is changed, so we need to clone your computer's MAC address to the router.
The MAC addresses of a computer in wired connection and wireless connection are different.
the router.
Network > LAN.
as an example.
access.
search engine
Clone, select Clone MAC Address and click Save.
71