Table of Contents
Advertisement
5
OUTPUT
Low level analog signal (4 Volt RMS).
Ch1 - Ch2 - Ch3 - Ch4 - Ch5 - Ch6 - Ch7 - Ch8
The cable is provided to be connected to the RCA cables going to the system amplifiers.
REAR VIEW
OUT 8 +
OUT 8 -
OUT 7 +
OUT 7 -
OUT 6 +
OUT 6 -
OUT 5 +
OUT 5 -
OUT 4 +
OUT 4 -
OUT 3 +
OUT 3 -
OUT 2 +
OUT 2 -
OUT 1 +
OUT 1 -
6
PRE IN - DIGITAL IN:
•
PRE IN. ANALOG (RCA) low level input
IN1 - IN2 - IN3 - IN4 - IN5 - IN6
The cable is provided to connect the preamplified signal outputs from the analog Master source with RCA connectors.
Through the software it will be possible to specialize the inputs by assigning the desired input
Input sensitivity adjustable from 0,8 to 6 V RMS
•
DIGITAL IN. S/PDIF digital input
S/PDIF-IN
The cable is provided to connect the signal from your source with digital output via a specific coaxial cable for digital
signals with RCA connection. S8 DSP accepts PCM signals at its input with a maximum sampling frequency up to
96 kHz 24 bit, therefore it is not possible to reproduce DOLBY DIGITAL (AC3) encoded multichannel signals from
audio/video sources (such as the audio of a film in DVD) or DTS.
REAR VIEW
S/PDIF +
S/PDIF -
IN 6 +
IN 6 -
IN 5 +
IN 5 -
IN 4 +
IN 4 -
IN 3 +
IN 3 -
IN 2 +
IN 2 -
IN 1 +
IN 1 -
6 mm
0.23 in.
WIRE SIZE 20 AWG
200 mm / 7.87 in.
6 mm
0.23 in.
WIRE SIZE 20 AWG
USER'S MANUAL /
200 mm / 7.87 in.
OUT 8
OUT 7
OUT 6
OUT 5
OUT 4
OUT 3
OUT 2
OUT 1
(see section. 7.5.4 - 7.5.5 - 8.2.2)
S/PDIF-IN
IN 6
IN 5
IN 4
IN 3
IN 2
IN 1
4
.
Orange
Orange/Nero
Brown
Brown/Black
Blue
Blue/Black
Purple
Purple/Black
Green
Green/Black
Gray
Gray/Black
White
White/Black
7
Advertisement
Table of Contents
