Table of Contents
Advertisement
7.5
I/O CONFIGURATION WIZARD
Before starting the "I/O Configuration Wizard" connect the source loudspeakers' outputs to the SPEAKER IN input
or the source PRE OUT outputs to the S8 DSP PRE IN input
(see section 5.2.3)
At this point it is necessary to know in advance the system to be implemented, since later, to change these
selections, you will have to run the guided procedure
In particular, the wizard will request:
-
What system will S8 DSP be installed on.
-
Which speakers make up the system ( E.g.: 3-way Front or Sub stereo or 2-way Rear etc. ).
-
If there are passive crossovers that handle groups of speakers ( E.g.: 3-way system with active mid-bass ).
-
Which type of main inputs will be used, if high level or low level.
This selection will not prevent the use of digital sources.
-
Which input/s will be assigned to each output, it is possible to configure an output system with stereo input,
customized, or with reconstruction of the input signal.
-
Click on the Settings menu and select I/O Configuration Wizard.
-
Press Start to start the Configuration Wizard.
-
Press Cancel to exit the Configuration Wizard.
26
USER'S MANUAL /
.
(see section 5.2.1)
7
Advertisement
Table of Contents
