Replacing Wing Fold Cylinder Seals - DAL-BO MaxiDisc Manual

After mounting the cylinder, activate the wing fold cylinders until the
piston rods begin to move in the cylinders. Next, activate the cylinders in
the opposite direction until the cylinder is back in the starting position.
Move the cylinders several times in this way.
Never allow bystanders within the operating radius of the implement.

Replacing wing fold cylinder seals

Fig. 16
1. For removal of the cylinder, see "Changing wing fold cylinders".
2. Empty the oil from the cylinder by moving the cylinder back and forth.
Side 24
1. Relieve the pressure in the cyl-
inders.
2. Disconnect the hoses.
3. Remove the split cotter pins and
the other pins. The cylinders are
now free.
4. Install new or repaired cylin-
ders. Remember to make sure
that the pin is engaged in the
stop and that the pins are se-
cured with split cotter pins.
5. Connect the hoses. After con-
nection, make sure that there is
no danger of the hoses becom-
ing ripped off or pinched.
Cylinder 80/40-350 (91805)
MaxiDisc
Fig. 15