Table of Contents
Advertisement
The MaxiDisc is preset in the factory, but it will always be necessary to make
some fine adjustments before use. Numerous adjustment possibilities make
your MaxiDisc more versatile and allow you to obtain optimum performance
from the implement.
Depth
The operating depth is controlled by the rear T-ring roller.
It is important that the turnbuckles have the same length on both of the packer
roller modules to ensure even depth penetration.
It might be necessary to readjust the top link after changing the depth. The
frame must always be horizontal.
Angle
The discs can be hydraulically adjusted from 0 to 20 degrees. With hydraulic
adjustment, all discs are adjusted at the same time.
Adjustments and Settings
To increase the working depth,
shorten the turnbuckles (A) by turn-
ing the turnbuckle with the supplied
combination spanner. To decrease
the working depth, lengthen the
turnbuckles. The depth indicators
show the depth reading, which must
be equal on both packer roller sec-
tions.
The angle of the front row and the
back row of discs can be adjusted
individually with the turnbuckle
(A). It is generally recommended
that you set the row in the back
slightly more aggressive than the
row in the front to prevent the ma-
chine from pulling unevenly.
MaxiDisc
Fig. 4
Fig. 5
A
A
Side 15
Advertisement
Table of Contents
