Use Philips Easylink; Change Settings; Access The Setup Menu - Philips HTS3260/12 User Manual

Use Philips EasyLink

The home theater supports Philips EasyLink,
which uses the HDMI CEC (Consumer
Electronics Control) protocol. EasyLink-
compliant devices that are connected through
HDMI connectors can be controlled by a single
remote control.
Note
•
Philips does not guarantee 100%
interoperability with all HDMI CEC devices.
1
Switch on the HDMI CEC operations on
the TV and other connected devices. See
the manual of the TV or other devices for
details.
2
Press (Home).
3
Select [Setup], then press OK.
4
Select [EasyLink] > [EasyLink], then press
OK.
5
Select [On], then press OK.
6
You can now enjoy the following Philips
EasyLink controls.
One-touch play
When you play a disc, the TV automatically
switches to the correct channel.
One-touch standby
When you press and hold
remote control, the home theater and all the
connected HDMI CEC devices (if they support
one-touch standby) switch to standby mode
simultaneously.
System Audio Control
When you play a device that has its audio
output routed to the home theater, the home
theater switches to the corresponding audio
source automatically.
To use one-touch audio, enable this feature and
follow the instructions on the TV to map the
connected devices correctly to the audio input
jacks of the home theater.
Audio Input Mapping
Updates audio input mapping if there are new
devices connected.
(Standby) on the
6

Change settings

This section helps you to change the settings of
your home theater.
Caution
•
Most of the settings are already configured
with the best value for the home theater.
Unless you have a specific reason to change a
setting, it is best to leave it at the default value.

Access the setup menu

1
Press (Home).
2
Select [Setup], then press OK.
» The setup menu appears.
3
Select a setup menu, then press OK.
See the following sections for information
about how to change the settings of your
home theater.
4
Press (Back) to return to the previous
menu, or press
Note
•
You cannot change a setting that is grayed out.
to exit.
EN
15