Advertisement
Remove the cover from your
doorbell chime.
After you've located your
doorbell chime and turned off
power at the breaker, remove
the cover from your chime
and set it aside for now.
Loosen the "Front" and
"Trans" terminal screws.
Make sure to keep the existing
doorbell wires in place.
6
Connect the Jumper Cable.
Connect one end of the
Jumper Cable to the "Front"
terminal, and the other to the
"Trans" terminal. It doesn't
matter which wire you
connect to which terminal.
Then re-tighten the
terminal screws.
7
Advertisement
