Solid-State Drive; Removing The M.2 2230 Solid-State Drive - Dell Vostro 3710 Service Manual

Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Insert the memory module into the memory-module slot.
3. Press down on the memory module until the memory module snaps into position. Ensure that both securing clips are locked
in place to secure the memory module.
4. Repeat Steps 1 to 3 for the next memory module, if applicable.
Next steps
1. Install the HDD and ODD
2. Install the 3.5-inch hard
3. Install the front cover.
4. Install the left-side cover.
5. Follow the procedure in

Solid-state drive

Removing the M.2 2230 solid-state drive

Prerequisites
1. Follow the procedure in
2. Remove the left-side
3. Remove the front cover.
4. Remove the 3.5-inch hard
5. Remove the HDD and ODD
About this task
The following image(s) indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the
removal procedure.
Steps
1. Remove the screw (M2x3) that secures the solid-state drive to the system board.
2. Slide and lift the solid-state drive from the M.2 card slot on the system board.
cage.
drive.
After working inside your
Before working inside your
cover.
drive.
cage.
computer.
computer.
Removing and installing components 27