Steps
1. Place and slide the tabs on the power-supply unit into the latches on the chassis.
2. Align the screw holes on the power-supply unit to the screw holes on the chassis.
3. Replace the three screws (#6-32) that secure the power-supply unit to the chassis.
4. Route the power-supply unit cables through the routing guides on the chassis.
5. Connect the system-board power cable to the system board.
6. Connect the processor-power cable to the system board.
Next steps
1. Install the
HDD and ODD
2. Install the
3.5-inch hard
3. Install the
front
cover.
4. Install the
left-side
cover.
5. Follow the procedure in
Fan shroud
Removing the fan shroud
Prerequisites
1. Follow the procedure in
2. Remove the
left-side
cage.
drive.
After working inside your
Before working inside your
cover.
computer.
computer.
Removing and installing components
41