Tstat (Thermostat) Mode; To Start The Stove In Tstat Mode; To Adjust The Heat Output; To Shut Down - Travis Industries AGP FS Manual

TSTAT (Thermostat) Mode

TSTAT mode allows you to use a thermostat to control room temperature. The stove automatically
turns on when the temperature drops below the thermostat setting and turns off (or too low) once the
thermostat setting is met.

To Start the Stove in TSTAT Mode

Press the TSTAT button on the
control panel. If there is a call for
heat from the thermostat, the
stove will enter the start-up
sequence for approximately 22
minutes.

To Adjust the Heat Output

Use the HEAT knob on the control panel to adjust the heat output.
NOTE:
Depending upon which TSTAT Program you are in (1, 2, or 3), the heat output may vary once the target
temperature is reached. For details see "Changing the TSTAT Program" on the following page.
TIP:
If you find that the stove turns on and off repeatedly, you may wish to turn the heat output to a lower
setting, which will provide a more consistent heat output over time, and eliminate the need for the
thermostat to repeatedly turn the stove off.

To Shut Down

Press the STOP or TSTAT
button on the control panel
or turn the thermostat down
below the room temperature.
The stove will begin the shut-
down process, which takes
approximately 45 minutes.
© Travis Industries
Operation
4/11/22- 1566
START
LOW HIGH LOW HIGH
HEAT FAN
AUTO FAN
WARNING
STOP TSTAT
GLASS AND SURFACES OF UNIT
CAN GET HOT ENOUGH
TO CAUSE SEVERE BURNS.
KEEP CHILDREN AND PETS AWAY.
START
LOW HIGH LOW
HEAT
AUTO FAN
TSTAT
STOP
25
www.travisproducts.com
www.travisproducts.com
HIGH
FAN
WARNING
GLASS AND SURFACES OF UNIT
CAN GET HOT ENOUGH
TO CAUSE SEVERE BURNS.
KEEP CHILDREN AND PETS AWAY.
AGP Stove