Ortech Y-H2 Operation & Installation Instructions page 25


The electrical connection must correspond to the electrical requirement noted on the rating plate, which is
placed inside the cooker hood. The appliance should now be connected to the electrical supply.

Check that the appliance is operating correctly by selecting each speed and switching the light bulbs on and
off.

Remove the hanging hook and then slide the lower chimney section downwards until it rests against the
main body of the cooker hood.

Use a stainless-steel cleaner and polish on the stainless-steel sections of the appliance.

If you are using the appliance in recirculation mode, then you should now fit the carbon filter. See the "fitting
the carbon filter" section on page 21.
5) If the glass canopy has not been pre-assembled by the factory,
then it should be fixed to the top of the main body of the cooker hood
at this stage.
6) Lift the main body of the cooker hood onto the angle bar and then fix
it into position using the 16 x M5 screws.

IMPORTANT: This stage of the installation process MUST be
completed by two people.

IMPORTANT: The 16 x M5 screws MUST be securely tightened.
7) If you are going to be using the hood in
extraction mode, you should fix the ducting
hose to the spigot.
25