Ortech Y-H2 Operation & Installation Instructions page 14

5) Icon D is the receiver for the remote control.
6) Press E, turn on the light. Press it again, turn off the light.
7) Press F, turn on power. Press it again, turn off power.
E. Touch control with oil removing (S1B)
A B
1) Press A, the fan runs at fast speed. Press again, the fan turns off.
2) Press B, the fan runs at slow speed. Press again, the fan turns off.
3) Press C, operate oil removing function for 10 minutes. Press again, turn off oil removing function.
4) Press D, turn on the light. Press it again, turn off the light.
5) When fan is ON, touch E once for a three-minute delay power off.
When fan is OFF, touch E for seconds to set clock. You can use A and B to set time. After setting, touch E
again to keep setting.
6) Press F, turn on power. Press it again, turn off power.
F. Touch and remote control with smoke or heat sensor (S2)
A B
1) Press A for 3 seconds to set clock. Touch B to set hour, C to set minutes. Press A again to keep setting.
2) Press B , the icon will twinkle for one minute, and then the smoke or heat function starts.
3) Press C once, the fan runs at high speed. Press it twice, the fan runs at medium speed.
rd
Press it 3 time, the fan runs at low speed. Press it 4
4) Press D, turn on the light. Press again, turn off the light.
5) When C or B is pressed, Icon E will be displayed. Press E, turn off power.
6)
Icon F is the receiver for the remote control.
C
C LED screen
LED screen
D E
th
time, the fan turns off.
14
D E
F
F