Lucci LEDlux JASPER DE19011BLK Installation Instructions

Installation Instructions
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of the product. Please keep the instructions for future reference.

Warranty

•
This product is covered by a 3-year warranty. Please retain the proof of purchase.
•
Warranty will be void if there is any damage due to improper usage or modification to the product.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the
warranty.

Installation requirements

•
Select a suitable location for the luminaire;
- Ensure it is on a flat and stable surface.
- This product is suitable for indoor use only.
- Do not place flammable material near or over the luminaire.
- Ensure the luminaire is not placed next to any air vents and is not in any moist or damp areas.
- If the luminaire is placed in an area prone to moisture, ensure that the area is well ventilated, and an
appropriately rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product
fault, and as such is not covered under warranty.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure no components are missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•
Do not plug into the mains power socket outlet before or during assembly. Only do so after the portable lamp is fully
assembled and ready to use for the first time.
Installation & Operation directions
1. Remove all packaging material from the luminaire.
2. Insert the plug into the mains socket outlet and ensure it is fully plugged in.
3. Use the ON/OFF switch to turn the luminaire ON/OFF.
4. Adjust the lamp head to your preferred lighting angle.
NOTE: The maximum angle of adjustment for the arm is 180° in the horizontal direction and 90° to the vertical
position.
When adjusting the arms, do not adjust more than the angles as above, as this may damage the internal wiring.
1 | P a g e
JASPER LED TABLE LAMP
SKU# 250540, 250541
Rated Voltage 220 – 240V~
v 1 . 0 ( 0 7 / 2 0 2 0 )