Lucci LEDlux STEM LED TABLE LAMP Series Installation Instructions

Installation Instructions
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of the product. Please keep the instructions for future reference.

Warranty


This product is covered by a 3 year warranty from the date of purchase. Please retain proof of purchase.

Warranty will be void if there is any damage due to improper usage or modification to the product.

Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.

Installation Requirements


Select a suitable location for this luminaire:
- Ensure it is on a flat and stable surface.
- This luminaire is suitable for indoor use only.
- Do not place flammable material near or over the luminaire.
- Ensure the luminaire is not installed in direct line of an air vent/system.
- If the luminaire is placed in an area prone to moisture, ensure that the area is well ventilated and an
appropriately rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product
fault, and as such is not covered under warranty.

This portable lamp is with only USB cable but not with a power adapter.

Take care not to pull any electrical wires during unpacking as this may damage the connection.

Lay out all the components on a smooth surface and make sure there are no components missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.

Check whether the luminaire has been damaged during transport. Do not operate/install any luminaire which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.

Do not plug into the mains power socket outlet before or during assembly. Only do so after the luminaire is fully
assembled and is ready to use for the first time.

Installation Directions

Remove all packaging material from the luminaire.
1. Install the standing rod to the base by tightening the screw used the provided Allen key.
2. Install the luminaire part to the standing rod.
3. Lock the luminaire part on the standing rod by tightening the screw.
4. Adjust the arms to your preferred lighting angle. Ensure the portable lamp is stable after adjusting the arms.
5. Plug the USB cable on an appropriate power adapter or an equipment which provides USB output.
NOTE: It is recommend to use adapters or the equipment, which can provide at least 1A current in the USB
output to achieve the best performance of the luminaire.
6. Use the cord line switch for on/off and dimming.
Tap the switch once and the luminaire will turn on at maximum brightness.
Tap the switch a second time and the luminaire will be at medium brightness.
Tap the switch a third time and the luminaire will be at minimum brightness.
Tap the switch a fourth time and the luminaire will be turn off.
1 | P a g e
STEM LED TABLE LAMP
SKU# 250900, 250901, 250902, 250903
Rated Voltage 5V DC
v 1 . 0 ( 0 7 / 2 0 1 9 )