Advertisement
The wire-feed speed is adjusted to fit your needs with help of the wire-feed speed regulator.
Symbols
Commissioning
Before operating the device, ensure that you have read and familiarised yourself with the information
and security instructions found in this user's manual. Further make sure to wear adequate safety gear,
to use sufficient aeration equipment, to have removed all flammable materials from the working area
and its vicinity, and to have an extinguishing equipment at hand in case of an emergency.
1.
Connect the earthing terminal to the workpiece you wish to wish to work on. Ensure that a proper
electric connection is established.
2. Remove all traces of rust or paint from the spot you wish to weld.
3. Use the controls to set the power output as well as the wire-feed speed according to the re-
quirements of your task. When configuring the device, make sure to consider the type of material
you are working on, its thickness as well as the thickness of the wire you are using.
4. Connect the power cord to the mains supply and turn the device on.
5. Cut excess wire hanging from the tip of the burner down to a length of 3 mm.
6. Position the tip of the burner about 6 mm away from the point that you want to start welding
from. The distance between the tip of the burner and the workpiece should thereby not exceed
10 mm.
7. Cover your eyes with a welding shield by closing the visor of your welding helmet or holding a
welding shield in front of your face.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
SLOW FAST
Meaning
Single- or three-phase transformer-rectifier
Metal-inert gas welding and metal active gas welding use cored
wire.
Suitable for supplying power to welding operation in environments
with increased hazard of electric shock
Protection class II
Item 62549
Wire feed speed
Page 6
01
2022-1
Advertisement
