After Finishing Work; Preparing For Transportation Or Storage - Stihl MSA 300.0 Instruction Manual

Hide thumbs Also See for MSA 300.0:
Table of Contents

Advertisement

Available languages

Available languages

20 After Finishing Work

: Sawing, low chain speed, low power
: Felling, bucking, average chain speed,
maximum power
: Limbing, maximum chain speed, maximum
power
The higher the power level, the faster the cutting attachment
will rotate.
To set the power level:
4
2
► Depress and hold the trigger switch lockout (1).
► While holding the trigger switch lockout, press down the
retaining button (2) with your thumb and release it.
The "STATUS" LED (3) and the LED showing the current
power level glow.
► Press the power level selector (4) to activate the next
power level.
Performing this operation at the highest power level will
cause the unit to return to the first power level.
Generally, battery life will be shorter when operating
continuously at the higher power levels.
When using the AP 300 S, only the ECO power level is
available.
0458-009-8601-A
3
1
20 After Finishing Work

20.1 Preparing for Transportation or Storage

WARNING
To reduce the risk of personal injury from unintended
activation or unauthorized use, switch off the chain saw,
engage the chain brake and remove the battery before
transporting the chain saw or putting it down. To reduce the
risk of injuries from the sharp cutters on the chain, always
cover the guide bar with the chain scabbard before
transporting or storing the saw.
To prepare the saw for transportation or storage:
► Switch off the chain saw, @ 17.2.
► Engage the chain brake, @ 15.1.
► Remove the battery, @ 16.2.
► Release the chain brake and loosen the chain.
► Re-engage the chain brake.
► Slide a chain scabbard over the guide bar so that it covers
the entire guide bar.
► If the battery or chain saw became wet during operation,
allow them to dry separately and completely before
charging or storing.
► Before using the saw, remember to re-tension the chain.
NOTICE
The chain contracts as it cools down. Failing to loosen the
chain after finishing work can damage the drive shaft and
bearings.
English
47

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Msa 300.0 c

Table of Contents