Table of Contents
Advertisement
Alio™ Note Card Reader
Serial Number Format: WWYLCCPPPPP
WW: Week of manufacture (01–52)
Y: Year of manufacture (9 for 2019)
L: Manufacturing location
CC: Configuration code
PPPPP: Sequential production number
3.4
Installing the Alio Note card reader
Alio Note card reader is a cashless payment system that combines a telemeter, antenna, card reader and a full-color display into a single
device and can be attached to Series 2000 and Talos note validators, both with or without recycler modules, and replace the bezel.
If the Alio Note card reader is supposed to replace a telemetry system in an already existing note validator, the note validator and the old
telemeter and antenna have to be removed before the Alio Note card reader can be installed.
For all installation work on the card reader, note validator, or machine, please observe the following safety instructions:
: :
44060-IG-01-01-EN_CPI_Alio Note Card Reader_Installation Guide_V1.0_.docx
Risk of injury
• Turn off power to the machine before installing or removing the card reader.
• The installation work described in this guide may only be carried out by qualified technicians or CPI-
trained and authorized personnel.
Risk of damage to the card reader
• The card reader control board is fitted with components that can be damaged by electrostatic discharge.
Please observe ESD precautions for components exposed to the risk of electrostatic discharge. Installers
should be properly grounded.
• The card reader must not be operated in the presence of flammable gases, fumes, or water.
• Keep water and other liquids away from the card reader. It is not suitable for use in areas where there
could be direct contact with water jets.
• When transporting the device only use its original packaging. It is only in this way sufficiently protected.
Note
• The Alio Note card reader's antenna is pre-installed inside the main housing and
has not to be installed individually.
• The Alio Note card reader's connection hub is the small puck attached to the card
reader and can be mounted inside the machine magnetically. This hub houses all
connections for other vendor peripherals. Each connection is unique and labeled
for easy routing.
• Please, confirm the asset, equipment or customer number and make sure you are at the correct machine
before installing the card reader.
Published by CPI
Installation
Fig. 2: Antenna location
Fig. 3: Connection hub
7
Advertisement
Table of Contents
