Download Print this page

Raider RD-GG08 User Manual page 13

Advertisement

NOTE! YOUR gasoline is equipped with a stopcock to interrupt the supply DIRECTLY FROM
FUEL TANK TO WORK SYSTEM (located to the right of the choke valve with LABEL "FUEL").
TRANSPORT OF GENERATOR Turn lever valve in position "OFF".
CAUTION!
IMMEDIATELY BEFORE WORK PLACE lever valve in position "ON" to ensure
Fueling ENGINE !!!
Attention! Electric generator is equipped with overload protection.
4. Cleaning and maintenance
4.1. Keep safety equipment, air slots and the motor housing contaminated by dust and dirt
as possible.
4.2. Clean the unit with a clean cloth or with compressed air at low pressure.
4.3. We recommend that you clean the unit after each use.
4.4 Periodically check the condition of the air filter, which is made of foam rubber and is
cleaned by washing with water.
4.5. Periodically proyaveryavayte contact surfaces of plugs to ignite in the presence of soot
or pollution clean them if necessary - replace the spark plug.
5. Troubleshooting.
Damage
The engine can not be started.
Engine starts and runs normally, but
does not send electricity.
The generator has little or no tension.
Check:
Spark plug
The fuel level
The position of the stopcock
Check the position of trigger ON / OFF
switch "
Switcher of the electrical feed
Reason:
Regulator or capacitor is defective.
Activated overcurrent protection
A dirty air filter
13

Advertisement

loading