Advertisement
12
www.raider.bg
3.2. Stop the engine
Before you stop the electric, leave it for a short time to work without load to allow the unit
to cool. "
1. In the event that the generator is connected to a circuit must set the switch for the
electric feeding in position "OFF" (switch labeled "CIRCUIT BREAKER")
2. Then disconnect the mechanical circuit of plug
3. Place the ignition switch contact in "OFF" position
4. Place the choke plate given to the situation on the final stop of the engine.
2. Place the ignition switch contact position "ON" (Figure 2)
3. Slide the choke fully left following the nameplate
(figure 3)
4. Pull the starter cord gently (9) until you feel the grip
(effort) and pull the ignition of the machine. (Figure 4)
5. After the start of the engine choke back to the starting
position.
ATTENTION !!! Before starting the engine, make sure
that you did not include electrical equipment to the
generator (Figure 5)
Advertisement
