Flexcom Reachfar V20 Installation And Operating Instructions Manual page 12

Flexcom Communication Ltd
Charging the battery
The device has a built-in battery that can be charged via the USB port. Your phone charger is suitable
for charging, but you can also use the USB connection of a computer or energy bank.
The corresponding USB charging cable is supplied with the device by the manufacturer. This is
connected to the device via a MICRO USB connector - if you do not use the factory cable, make sure
that it is type-compliant!
The charge level is indicated by a four-member LED indicator.
Charge the device for at least 8 hours before using it for the first time!
When the battery is fully charged (all four LEDs are lit), disconnect the charging cable.
The device does NOT have overcharge protection, so prolonged or continuous charging
will shorten the life of the device or, in worse cases, damage it.
Use a charger that supplies 2 A to the device at a voltage of 5 V. Chargers with a higher
capacity can damage the battery.
It is recommended to fully discharge the battery every 3 months and then
recharge it! Do not use the device while charging, this applies especially to the
energy bank function!
Application installation, access
In order to operate the device and other services based on it, the distributor provides mobile and
computer applications in the subscription system. The PC program is accessible via a browser at
https://gpspositions.net/map/, and you can install the phone application on your phone in one of the
Installation and operating instructions (2021/03/24)
12/25