Servicing The Inlet Valve; Replacing The Outlet Valve - WAGNER Paint Crew Plus Owner's Manual

Hide thumbs

Table of Contents

Cleaning or replacing the inlet valve may be required if the unit has priming problems. This may be caused by improper

cleaning and/or storage. Replacement kits may be ordered by calling customer service (1-800-328-8251).

1. Remove the hopper. Insert the the inlet valve tool into the

inlet valve area (a).

2. Twist counter-clockwise and remove inlet sleeve and

plastic ring from its housing. You will need to attach the

inlet valve tool to a ratchet wrench extension with a

5/8" socket in order to remove it.

3. Inspect the threads on the inlet sleeve and the inlet

sleeve O-ring. Remove any accumulated paint.

4. Insert the inlet valve tool into the inlet valve fitting. Using

the ratchet and socket, twist counter-clockwise and

remove from its housing.

5. Retrieve the inlet valve and the inlet valve O-ring from the

inlet valve housing. Clean or replace and lubricate the O-

ring with a light household oil.

6. Set the inlet valve O-ring back into the housing, and set

the inlet valve on top of it.

7. Replace inlet fitting into the housing. Tighten with the

inlet valve tool and ratchet.

8. Replace the seal. Place the inlet sleeve O-ring onto the

inlet valve fitting, and replace the inlet sleeve by twisting it

clockwise.

9. Replace the hopper.

Replacement of the outlet valve may be necessary if your spray performance remains poor after having performed all the

steps contained in the Spraying Troubleshooting section of this manual. Replacement valves are available by calling

customer service (1-800-328-8251).

1. Unscrew the outlet valve from the outlet valve housing

using an adjustable wrench.

2. Inspect the inside of the outlet valve housing (a). Clean

any accumulated paint.

3. Replace with a new outlet valve. Tighten into outlet valve

housing with an adjustable wrench.

English