AIR-EAGLE
900MHz RF Transceiver
MODEL 461-40400-DC
DESCRIPTION
The A
-E
XLT P
RF T
IR
AGLE
LUS
control of electronic equipment and apparatus at distances up to 1 mile
away (longer ranges can be achieved with external antennas). This
model comes equipped with four dry contact inputs and four relay
outputs. This allows the user to not only transmit information out but
receive a confirming signal back that the operation was performed A
terminal strip has been provided for interfacing with external dry
contact inputs as well as dry contact relay outputs. The Air-Eagle XLT
TRX is user-programmable for up seven network frequencies to allow
multiple systems to operate simultaneously in the same area.
INSTALLATION
DISCONNECT Power from all equipment before installation.
1.
Mount the A
-E
XLT PLUS TRANSCEIVER in a convenient
IR
AGLE
location.
Install input & output wiring to the terminal strip (Note – terminal strip
2.
header lifts off base for easy wiring)
3.
Install antenna to TNC connector on the right side of the enclosure.
4.
Connect supplied power input cable to your external power source.
TERMINAL STRIP WIRING
INPUTS
1
Common Input 1
9
2
Input 1
10
3
Common Input 2
11
4
Input 2
12
5
Common Input 3
13
6
Input 3
14
7
Common Input 4
8
Input 4
Terminal #1
Terminal #2
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
XLT
provides two-way wireless
RANSCEIVER
OUTPUTS
N/O Relay #1
15 N/O Relay #3
C Relay #1
16 C Relay #3
N/C Relay #1
17 N/C Relay #3
N/O Relay #2
18 N/O Relay #4
C Relay #2
19 C Relay #4
N/C Relay #2
20 N/C Relay #4
DC INPUT
(-) 9-36VDC Input
(+) 9-36VDC Input
PRODUCT INFORMATION
BULLETIN
GENERAL OPERATION
Contact closures on inputs 1 thru 4 in the control transceiver transmit
to activate relay #1 thru #4 in the remote transceiver. Inputs from the
remote equipment provide closures to remote transceiver that transmit
to energize relays #1 thru #4 in the control transceiver.
INPUT
ACTION
ACTIVATED
"1"
Transmits channel 1 command to remote unit
"2"
Transmits channel 2 command to remote unit
"3"
Transmits channel 3 command to remote unit
"4"
Transmits channel 4 command to remote unit
INPUT CODE
ACTION
RECEIVED
"1"
Relay #1 energizes, maintained momentary
"2"
Relay #2 energizes, maintained momentary
"3"
Relay #3 energizes, maintained momentary
"4"
Relay #4 energizes, maintained momentary