Yamaha FZ 25 2021 Supplementary Service Manual page 74

1 Rear wheel speed sensor lead
2 Plain washer
3 Brake hose union bolt
4 Rear brake hose
5 Rear brake hose holder
6 Battery box
7 Frame
8 Footrest assembly
9 Clamp
0 Rear brake light switch lead
A Rear brake master cylinder
B Split pin
C Rear brake reserve hose guide
D Rear brake reserve hose
E Rear brake caliper
F Rear brake hose (ABS hydraulic unit to rear
brake caliper)
G Rear brake hose (ABS hydraulic unit to rear
brake master cylinder)
CABLE ROUTING
È Fix the clamp on the paint mark of brake hose
protector and white tape of wheel speed sensor.
É Air shall be completely removed.
Ê Clamp shall be inserted in the brake light switch
stay.
Ë Wheel sensor shall be clamped at white tape.
Ì Clamp shall be inserted in the hole of battery
box.
Í Set the tip of the clamp as shown, cut the tip of
the band, maximum length of band tip 5mm.
Î Adjust the brake light switch until brake light turn
"on" before brake starts to be working.
Ï Install the spring hook into the brake pedal
spring stay as shown.
Ð Pin shall be inserted from outside of the vehicle.
Ñ Reserve hose shall be assembled through the
clamp of plate.
Ò Rear brake hose shall be assembled to brake
caliper by touching right side.
Ó Brake hose shall be assembled by touching rear
master cylinder.
Ô Fit the clamp on white tape mark at wheel speed
sensor.
Õ Rear brake hose (ABS hydraulic unit to rear
brake caliper) shall be assembled.
2-37
SPEC