Advertisement
scsi-ag.bk : scsiadm.fb4 Page 3 Tuesday, September 15, 1998 2:25 PM
Boot Device
Configuration Menu
All manuals and user guides at all-guides.com
Additional Options:
• Boot Device Options
Press
to display the Boot Device Configuration menu,
described on the next page.
• SCSI Device Configuration
Press
to display the SCSI Device Configuration menu.
• Array 1000 BIOS
This option is enabled by default, and instructs the system to use the
special BIOS for the FastRAID option.
• Advanced Configuration Options
Press
to view the Advanced Configuration Options menu.
This menu lets you configure the SCSI boot device. To find out the
SCSI ID of a specific SCSI device, you can run the SCSI Disk Utilities
(refer to page 7).
Boot Device Configuration
Select SCSI peripheral from which to boot
To view peripheral by ID# select "SCSI Disk Utilities" from previous menu
Boot SCSI ID ................................................. 0
Option Listed Below Has NO EFFECT if MULTI LUN Support is Disabled
Option Listed Below Has NO EFFECT if MULTI LUN Support is Disabled
Boot LUN Number .............................................. 0
Use the
and
display a menu with a selection of values.
• Boot SCSI ID
This parameter is the SCSI ID of the boot device. The default value
is 0.
• Boot Lun Number
More advanced SCSI devices can have several logical units. This
option indicates the logical unit (or Lun) on which to boot for the
drive chosen in the
Use the HP Setup program to select the boot device. You enter Setup
by pressing
during startup.
F2
(only if HP FastRAID is installed)
Boot Device Configuration
keys to move between options. Press
. The default value is 0.
Boot SCSI ID
Configuring the SCSI Bus
to
English
3
Advertisement
