Advertisement
scsi-ag.bk : scsiadm.fb4 Page 2 Tuesday, September 15, 1998 2:25 PM
Configure/View
Interface Settings Menu
All manuals and user guides at all-guides.com
Configuring the SCSI Bus
It is recommended that you do not change these settings.
SCSISelect(TM) Utility v1.xxx
Configuration
SCSI Bus Interface Definitions
Host Adapter SCSI ID . . . . . . . . . . . . . . 7
SCSI Parity Checking . . . . . . . . . . . . . . Enabled
Host Adapter SCSI Termination ...................Automatic
Additional Options
Boot Device Options
SCSI Device Configuration
Advanced Configuration Options . . . . . . . . . Press <Enter>
<F6> - Reset to Host Adapter Defaults
BIOS Information
Interrupt (IRQ) Channel . . . . . . . . . . . . . . 15
I/O Port Address
SCSI Channel Interface Definitions:
• Host Adapter SCSI ID
Changes the adapter SCSI ID from its default value of 7.
• SCSI Parity Checking
Enable or disable host adapter SCSI parity checking. Most currently
available SCSI devices do support SCSI parity. You should disable
SCSI Parity Checking if any of the attached SCSI devices do not
support SCSI parity.
• Host Adapter SCSI Termination
It is recommended that you leave this field on its default setting of
. This way, if the host adapter detects a SCSI device
Automatic
connected to either its internal or external connectors, then it
enables its terminators (the adapter is at the end of the SCSI bus). If
the host adapter detects devices connected to both its internal and
external connectors, then it disables its terminators.
2
English
. . . . . . . . . . . . . . Press <Enter>
. . . . . . . . . . . Press <Enter>
. . . . . . . . . . . . . . . . . F800h
Advertisement
