Gainsborough K553 Quick Start Manual

Clip on Butterfly Solar Lights Pack of 8
K553
v001: 27/10/21
Please read and retain these instructions for future reference
Dimensions
(H) 9.5 x (W) 8.5 x (D) 7.6
•
COLOURFUL SET OF 8 SOLAR BUTTERFLIES
•
2 IN PURPLE, 2 IN ORANGE, 2 IN YELLOW AND 2 IN BLUE
•
EACH BUTTERFLY HAS A CLIP AND SOLAR PANEL SO YOU CAN CLIP ANYWHERE YOU LIKE, FROM
TREE BRANCHES, TRELLIS', HEDGES, PLANTS ETC SO IN THE DAY THEY ADD SOME SUMMER COLOUR
AND AT NIGHT THE WHITE LED INSIDE EACH WILL AUTOMATICALLY ILLUMINATE FOR A PRETTY
NIGHTTIME GLOW (LED not replaceable)
•
SCATTER THEM AROUND YOUR GARDEN
Battery: 1 x 1.2V 40MAh Ni-MH button cell (incl.)
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
Before using first time
Remove the clear plastic film from the surface of the solar panel (if
present).
Allow lamp to charge for at least 8 hours in full sunlight with the ON/OFF
switch in the ON position. The ON/OFF switch is located on the underside
of the solar panel. Once the batteries are fully charged, leave the ON/OFF
switch to ON. If the light does not turn on after dark refer to Maintenance
section.
NOTE: In order to verify that the button is correctly in the "ON " position,
cover the solar panel with your hand and light should turn "ON" automatically.
Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of
hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed
in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the
light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from
coming on, or cause it to turn off automatically. Clip the lights onto objects within the location.
ALWAYS POSITION IN DIRECT SUNLIGHT